I finished up the second Freestyler. Haven't flown it yet, but now I have two of them ready to fly. Did some more work on the Tanga. Servo tray is cut out, ballast tube cut, layout and ballast tube loading checked with servos, JR9300 RX and 5-cell pack. I just need to make wiring harness and test fit wiring around ballast tube. Then everything can be glued in.
Not thrilled with the angle of the flap RDS hardware. It doesn't look like it's good for as much flap travel as I would like. I have some 3mm rod on order to make some new wires. And I need to measure the aluminum piece just in case I have to make a new one.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment